SARPOL RP08

Properties of Part A:
Density @ 25 C, ISO 1675, g/cm³ 1.7
Pasta Viscosity

Properties of Part B:
Density @ 25 °C, ISO 1675, g/cm³ 1.6
Pasta Viscosity

Properties of Compound A + B:
Density @ 25 °C, ISO 1675, g/cm³ 1.67
Pasta Viscosity

Properties of Hardening
Gel Time, ASTM D2471 minutes 30
Curing Time @ 25 °C, hours 6
Coverage
To achieve a thickness of 6 mm, the coverage rate will be 0.1 square meters per 1 kg.

GENERAL INFORMATION
This product is not recommended for use in oxygen-rich and/or pure oxygen systems and should not be selected as a sealant for chlorine or other strong oxidizing materials.

For information on the safe handling of this product, consult the safety data sheet (SDS).

Surface Preparation

Una corretta preparazione della superficie è fondamentale per le prestazioni a lungo termine di questo prodotto. I requisiti esatti variano in base alla gravità dell’applicazione, alla durata prevista e alle condizioni iniziali del substrato.

1. All welds and weld spatter shall be ground flush. Blast clean all surfaces to be coated with angular grit to achieve a profile of 50-70 microns and near-white metal cleanliness (SIS SA 2½ /SSPC-SP 10).
2. After blast cleaning, the metal surfaces must be clean and coated before any oxidation occurs.
3. For vertical or ceiling applications, the application of expanded metal mesh is recommended.

Mode of Application:

1. Film thickness per layer: minimum 6 mm.
2. Apply the material to the prepared surface by first forcing a thin layer deep into the consistency of the substrate.
3. Immediately thereafter, build up to the required finished thickness.
4. At 25°C, working time is 30 minutes. Functional hardening for handling in 6 hours.

Check:

• Ispezionare visivamente per fori e mancanze subito dopo l’applicazione.

• Una volta che il rivestimento è indurito, ripetere l’ispezione visiva per confermare l’assenza di fori, vuoti o aree danneggiate.

• Check the coating thickness, above all in critical areas.

Attenzione: Utilizzare un respiratore d’aria approvato a pressione positiva durante la saldatura o il taglio in prossimità del composto indurito. Non utilizzare fiamme libere sul composto.

Repairs

Any voids, holes, or thin areas found in the coating can be repaired by lightly abrading, cleaning the area, and applying additional product.

Cleaning

Immediately after use, tools must be cleaned with a suitable detergent, e.g., a solvent such as acetone or isopropyl alcohol. Once hardened, the material can only be removed mechanically.