RESINALCERAMICA® T250 A&B provides the following product specifications:
MSDS A
MSDS B
|
Technology |
Epoxy |
|
Chemical Type |
Epoxy |
|
Appearance – Mix |
White Paste |
|
Components |
2-part components – Resin & hardener |
|
Mix ratio (Weight – Volume) Resin: Hardener |
2 : 1 |
|
Polymerisation |
At ambient temperature after mixing |
|
Application |
Anti-wear Coating |
|
Application Temperature |
15 - 30°C |
|
Service Temperature |
150°C max. |
|
Benefits |
Refurbishment and repair of worn metal partsProtecting metal surfaces from abrasive agentsCeramic fill – for excellent abrasion resistanceThixotropic – provides abrasion resistance on vertical and overhead surfaces |
RESINALCERAMICA® T250 A&B is a two-part epoxy paste with ceramic fill designed to protect, rebuild and repair high-wear areas of systems and machinery. This product is typically used in applications with an operating temperature of range of -30 to 150 ºC. Typical applications include cyclones and separators, dust collectors and extractors, pump bodies and impellers, fan blades and housings, chutes and hoppers, bends and diverters.
Properties of A + B Mixture:
Density @ 25 °C, ISO 1675, g/cm³ 2.95
Paste Viscosity
Hardening Properties
Open time, ASTM D2471 minutes: 30
Time between coats @ 25 °C, hours: 1
Polymerisation Time @ 25 °C, hours: 72
Coverage
To achieve a thickness of 6 mm, coverage of 0.06 m² per 1 kg will be achieved.
Surface Preparation
Correct surface preparation is key to the long-term performance of this product. The exact requirements will vary depending on the severity of the application, the expected service life and initial conditions of the substrate.
Method of Application
Check:
Important: Use an approved self-contained respirator when cutting or welding near the hardened compound. Do not use naked flames on the compound.
Repairs
Any voids, holes or areas of insufficient thickness found in the coating can be repaired by lightly scuffing and cleaning the area and then adding further product.
Cleaning
Tools must be cleaned immediately after use with a solvent such as acetone or isopropyl alcohol. Once hardened, the product can only be removed via mechanical means
2
The technical data contained herein are for reference only. Please contact the tencical department for assistance and recommendations on specifications for this product.
Storage
Store the product in the closed container in a dry place. Storage information may be indicated on the labeling of the product container.
Optimal storage: 8 to 21 °C. Storage below 8 °C or above 28 °C may adversely affect product properties. Material removed from containers may be contaminated during use. Do not return the product to the original container. SARO Srl cannot assume responsibility for product contaminated or stored under conditions other than those previously stated. If further information is needed, please contact technical support or your local representative/vendor.
The information provided in this data sheet (TDS) including recommendations for the use and application of the product is based on knowledge and experience of the product as of the date of this TDS. The product may have a variety of different applications as well as different application and working conditions in the use environment beyond control. SARO Srl, therefore, is not responsible for the suitability of the product for the processes and production conditions for which it is used, as well as the applications and results expected. It is strongly recommended that you conduct your own tests to confirm its suitability. Any liability in connection with the information contained in the data sheet or any other written or oral recommendation concerning the product is excluded.
SARO Srl expressly disclaims all warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose, arising out of the sale or use of SARO Srl's products. SARO Srl expressly disclaims any liability for consequential or incidental damages of any kind, including lost profits.
